Pass test crimping wires when the electrical equipment is often found in core crimp individual wire feeding is not in place, or to a position not lock after contact unreliable. Analyze the reasons for individual installation at a burr hole thread stuck or dirty. Particularly the use of plants have been installed electrical equipment to the last few holes of a plug seat, found the flaws after the other hole had been installed crimped wire discharged one by one, to replace the plugs and sockets. Further, since the wire diameter and crimping aperture select a mismatch, or due to operational errors crimping process, crimp terminal will result in an accident is not strong. For this reason, the production plant in front of the finished product to plug (seat) for the delivery of all the mounting holes through the sample test, which uses handling tools crimped wire pins or jack to position simulation, PCB high pressure silicone wire material, check whether locked. Based on technical conditions prescribed for by the root crimped wire pull-off force of inspection. There is no reliable terminals, there is no reliable system engineering. Failure and reliability are two sides of the corresponding and interconnected in a contradiction. Through terminals reliability screening find all kinds of failure modes and failure mechanisms can lead to a lot of lessons learned and to remove all risks, supply PCB high pressure silicone line, to improve the design, engineering, testing and use to provide a scientific basis, PCB high pressure silicone line, it is also revising and developing terminals and technical conditions important basis. Looking for preventive measures fail, the failure to achieve the transformation into a reliable, PCB high pressure silicone line wholesale, is the ultimate purpose of failure analysis. 1, deformation splicing portfolio digit growth, the main reason is due to irrational structure led to both the uneven stitching Falcon around up and down, as shown in the structural design to consider the force and deformation of its falcon splicing direction. 2, screw anti-out problem, in this regard, I recommended to use the neck to prevent out, because it avoids the anvil anti-out compared to the screw rod and the anvil of the tolerances annoyance. Tolerance and reliable construction easy to control. PCB high pressure silicone line, Xu Chong-electronic products factory, PCB high voltage silicone wire material from the Dongguan Shijie Xu Chong-electronic products factory provided. PCB high pressure silicone line, Xu Chong-electronic products factory, PCB material is high pressure silicone line Dongguan Shijie Xu Chong-electronic products plant (chuangxs.1688.com) (www.chuangxs.1688.com) this year introduced a new upgrade The above picture is for reference only, please call Tel picture on this page or to obtain the latest information, contact: Mr. Hu.